2 | 028-0377-03
November 2015
I
NSTALLATION
1.
Remove security screw on bottom of
Room Controller cover.
2.
Open unit by pulling on bottom side of
Room Controller (fig. 1).
3.
Remove wiring terminals from sticker.
4.
Read FCC ID and IC label installed in
cover.
Location
1.
Should not be installed on an outside
wall.
2.
Must be installed away from any
direct heat source.
3.
Should not be installed near air
discharge grill.
4.
Should not be affected by direct sun
radiation.
5.
Nothing should restrict vertical air
circulation to Room Controller.
Installation
1.
Swing open Room Controller PCB to
left by pressing PCB locking tabs (fig.
2).
2.
Pull cables 6” out from wall. Ensure
wall surface is flat and clean.
3.
Insert cable in central hole of base.
4.
Align base and mark location of two
mounting holes on wall ensuring base
is in proper orientation. Arrow on
base should be facing up.
5.
Install anchors in wall.
6.
Insert screws in mounting holes on
each side of base (fig. 2).
7.
Gently swing back the circuit board
on base and push until tabs lock.
8.
Strip each wire 1/4 inch from end.
9.
Insert each wire according to wiring
diagram.
10. Gently push excess wiring back into
hole (fig. 3).
11. Re-Install wiring terminals in correct
locations (fig. 3).
