11
2.5
Camera Installation
The following description demonstrates how to directly install the camera to the
ceiling or to the wall.
Step 1:
Loosen the two security screws on the
camera with the supplied security torx and
open the dome cover.
Step 2:
Place the camera at the installation
location. Mark the position of the two screw
holes, indicated in the figure to the right, on
the ceiling/wall. Then draw a line along the
concave edge of the camera to indicate the
cable position.
Step 3:
On the ceiling/wall, draw a dot 0.78 in.
(20mm) above the center of the marked
concave edge. Set the marked dot as the
center, draw a cable entry hole with 1.18 in.
(30mm) diameter [radius is 0.59 in.
(15mm)] and drill the cable entry hole.
Step 4:
Drill a hole slightly smaller than the supplied plastic screw anchor on each
marked screw hole. Then insert the plastic screw anchors into the drilled holes.
