Adjustable Head
The
Adjustable Head consists of three
parts: a circular base, a platform, and a
clamping piece, plus related hardware.
The
may be packed in either one of
two ways. In one, a
reusable hex
bolt is used to retain the base, platform, and
clamp in proper relation to each other. The
stamped hex nut, however, is not to be used in
mounting the unit and
be discarded. In
the other type of packaging, a
hex
bolt and washer are packed in a separate bag.
1. To install the
remove the bolt and
washer from the adjustable head (if this
packing method has been used), or from the
separate bag. Slide the washer onto the bolt
up to the head, and insert the bolt through
the clamp and base. The washer prevents the
bolt head from recessing into the clamp. The
threaded portion of the bolt will protrude
about
from the bottom of the circular
base.
2. Align the adjustable head in the desired
direction.
3. Thread the bolt into the threaded hole in
the appropriate wall or column mount. Tighten
ADJUSTABLE HEAD
the bolt finger tight, followed by an
additional
turn. See Figure 5.
CAUTION: Further tightening could damage the
unit. Do not overtighten.
MAINTENANCE
The
and
Wall Mounts and
Associated Equipment do not require
maintenance.
PLATFORM TIPPED FOR
EASY BOLT INSERTION
C L
J L A R B A S E
Figure 5
Adjustable Head Installation
X605-488
5
