REF. NOTES
SHEET NO.
REV.
SEC.
Supersedes X262-287
X605 488
INSTRUCTIONS FOR
INSTALLATION AND OPERATION
MODELS
AND
HEAVY-DUTY WALL MOUNTS
GENERAL
SCOPE
The information in this instruction manual
covers the installation of Models
and
Heavy-Duty Wall Mounts, as well as
their Associated Equipment and Accessories.
INTRODUCTION
Models
and
Heavy-Duty Wall
Mounts are designed to support pan-and-tilt
drives, scanners, camera/lens systems, and
environmental housings with total camera
station load ratings of up to 200 pounds
(91 kg)* for the
and 130 pounds (59 kg)
for the
These industrial, outdoor units
are constructed of corrosion-protected steel.
ASSOCIATED EQUIPMENT
AND ACCESSORIES
MOUNTING ACCESSORIES
Model
Corner Mounting Bracket:
For
corner mounting capabilities.
Models
and
Support Struts:
Provide added strength for heavy loads.
Model
Pole Mounting Adapter:
Accommodates pole diameters from four to
10
inches (10.2 cm to 25.4 cm). See instruction
manual X532.
ADJUSTABLE HEADS
Model
Provides fixed heavy-duty
wall mounts with repositioning capabilities.
WALL MOUNT
Model
Provides extra support for
the heaviest loads.
INSTALLATION
Note: U
SC
steel hardware for
outdoor
GENERAL INSTRUCTIONS
Bolts should preferably extend through the
structure with nuts and washers used on the
opposite side. Studs should be either
anchored in concrete or welded to steel. If
the mount is to be attached to a blind
structure, make certain that the fasteners
used have a minimum pull-out strength of
1500 lb each. (Never use lag screws in the
end grain of wood.)
If used with Adjustable Head
load rating reduced to 100 lb (45.4 kg).
Product specifications subject to change without notice.
p a r t n u m h e r 8 0 0 6 - 8 6 0 5 - 0 0 - 0 0
INDUSTRIES INC.
525 BROAD HOLLOW ROAD, MELVILLE, N.Y. 11747 TEL:
TELEX: 144581
TOLL FREE:
800-645-9116
(OUTSIDE OF NEW YORK)
