2
••
Installation
X399 Rev 599 V2000WM Wall Mount
V2000WM Wall Mount
To install the Model V2000WM wall mount, secure the base to the wall with at least four ¼-in. (7 mm) lag screws
or bolts. See Figure 1. Do not overtighten screws. Pull screws snug and then tighten ½ turn beyond snug
position. There are three additional knock-out holes that can be used as required. There is a feed-through hole
for routing cable through the mount. A bushing is supplied to prevent deterioration of the cable.
Figure 1
V2000WM Outline Drawing
V2400AH Adjustable Head
The V2400AH Adjustable Head consists of three parts: a circular base, a platform, and a clamping piece, plus
related hardware (3/8 in. hex bolt and washer). Refer to Figure 2.
1. Remove the bolt and washer from the accessory bag. Slide the washer onto the bolt up to the head, and
insert the bolt through the clamp and base. The washer prevents the bolt head from recessing into the
clamp. The threaded portion of the bolt protrudes about 3/8-inch (0.95 cm) from the bottom of the circular
base.
2. Align the adjustable head in the desired direction.
3. Thread the bolt into the threaded hole in the mount. Tighten the bolt finger tight, followed by an additional ½
turn.
