6
|
Quick Operation Guide
Setting the DIP Switches
There are two DIP switches that must be set on the Surveyor HD. One is
on the Communications Interface (CI) board and one on the Main board.
SW1 4-position DIP switch is on the Communication Interface (CI) board.
For SW1 all poles should be set to OFF (default).
DIP Switch Location on CI Board
Caution
Changing the positions on the DIP switch on the Main board should only
be done by a qualified person. Position 1 is used only if it is necessary to
force the unit into default setup if network or system connections are lost.
Be sure to reset this switch back to the OFF position before the next
power up to avoid a constant return to defaults, resulting in not being able
to enter the camera’s IP to use the Web Browser. The camera dome is
shipped with a default static IP of 1.1.1.2.
The Main board has an 8-position DIP switch SW1. The settings for the
positions of this DIP Switch are:
Position 1 - Set Network Address. OFF = Default Position, do not
set network defaults. ON = Set k default network address (1.1.1.2);
must be reset OFF after reboot and before next power up.
Position 2 – Unused (set to OFF)
Position 3 – For factory use only. OFF is Default.
Position 4 – Unused (set to OFF)
