Vicon SMS Enterprise, Руководство по установке и эксплуатации, Страница: 12 / 16

9
Migrating from a Basic Network Controller to an Enterprise
Network Controller
If you are upgrading your solid-state, basic Network Controller system by migrating to a disk-based
Enterprise or Enterprise Ultra, complete the following procedures. You will need to replace the
Controller/Node blade circuit card that is currently in your solid-state system with a Node-only card.
Back up the Your data from the current system
1. Login to the current system.
2. Select Administration : Utility : Backup System .
3. Enter a comment to explain the purpose of this backup.
4. Click Full Backup .
5. When the backup is complete it is listed in the Existing Backups section.
6. Download a copy of this backup to a disk drive by clicking the get link in the Download?
column.
7. In the File Download dialog click Save .
8. In the Save As dialog browse to the location where you wish to save this backup.
9. Click Save .
Replace the solid-state Network Controller/Network Node with a Node-only blade
1. Select Setup : Site Settings : Network Nodes .
2. From the Name drop-down select the Node that you will replace.
3. Write down the Node name and Unique Identifier for this node. You will need to know this
later to complete your configuration.
4. Select Setup : System Maintenance : Utilities .
5. Click the Shutdown Now button in the System Functions section of this page.
6. Please wait for the system countdown to complete and you will hear two beeps.
7. Remove power from the system.
8. Replace the Controller/node blade with a Node-only blade.
9. Re-power the now Node-only system.
NOTE : By default, nodes come from the factory set to DHCP.
Start the Enterprise or Enterprise Ultra Network Controller and restore the data backup
NOTE : If you set your Enterprise IP settings to the same settings as the previous controller
then router settings, port forwarding settings, and Node auto-discovery settings will not need
to be changed.
1. Connect power and the network to the Enterprise Network Controller.
2. Open the drive door on the front panel of the Enterprise controller and press the power
switch. The system may need 2 to 3 minutes to launch.
3. Open your browser and enter the Enterprise IP address into the address line. Press the Enter
key.