Refer to Table 7 and carefully insert the appropriate pin into the appropriate
connector receptacle.
Refer to Figure 7. For example, if a red conductor at the other end of the cable has been connected to
response out
the pin connected to the red conductor at the
of the cable should be inserted
into receptacle 1, response in +. Complete the chart in Table 7.
When
into the
of
connector.
a mistake made, a
too/ (AMP
91067-3) must be used remove
ph.
does not
tool:
VIEW OF WIRING SIDE
Figure 7
Connector
9.
Refer to Table 7 and Figure 7 and insert a pin into each receptacle listed, using one conductor set in the
dual cable for pins 1, 2, and 6, and one conductor set for pins 3, 7, and 8. If Belden 9182 was chosen, use
one cable for pins 1, 2, and 6, and a second Belden 9182 for pins 3, 7, and 8. Complete the chart in Table
7 as it will be needed for connections to the keypad, distribution line control or PC connected to jack J3.
Table 7
Keypad Connections
Command in
10. Insert the inner shield into the grooves of the connector. Refer to Figure 5a on page 13.
11. Close the inner shield. Insert the outer shield into the grooves of the connector. Refer to Figure 5b and c.
12. Close the outer shield until the tabs snap over the tabs on the inner shield. Refer to Figure 5d.
13. Slide the ferrule until it covers the end of the closed shields. Crimp the larger end of the ferrule to the
cable(s).
14. Connect the assembled cable to jack J3 on the V1422 rear connector panel. Refer to Figure 3 on page 9.
X826 Rev 798 NOVA V1422
Installation 15