Vicon Kollector Pro, Руководство по установке и эксплуатации

Страница: 19 / 30

XX128-02-00 Rev 904 Kollector Pro Network Digital Video Recorder Operation
••••
13
Chapter 4
Operation
About This Chapter
This chapter details power on, booting and power off of the Kollector Pro Digital Video Recorder. For full
programming and operation information, refer to the Kollector Pro Software manual, XX128-3X (where X is a
revision number between 0 and 9).. The following sections provide information as follows:
•
=
Powering-on the Recorder guides the user through proper power on and boot procedures.
• =
Powering-off the Recorder guides the user through proper shut down procedures.
Powering On the Recorder
To power on the system:
1. With the recorder set up as shown in Chapter 3, Installation , verify that the rear panel toggle switch is in
the ON position (“I” pressed in).
2. Open the front panel cabinet and press the front panel toggle Power Switch towards the "I" position. The
button will switch back to the "O", which is its default position, even when the system is running.
IMPORTANT: Do not press any keyboard buttons at this time.
When the recorder completes booting and the Main Screen is displayed. For more details, refer to the
Kollector Pro Software Manual, XX128-3X.
Powering Off the Recorder
To power off the system:
•
= With the recorder booted and operational, press the Shutdown button in the Site Setup window. Follow
the screen prompts and the system will return to the ViconNet desktop. Use the Start button to
completely shutdown the system.
OR (this not recommended, due to the possibility of data loss)
Momentarily press the power switch. The system switches off, component by component.