6
7 Removal of Dome Cover
1. Using the supplied Torx T-20 security wrench, loosen the three tamper-proof
screws holding the dome cover to the enclosure assembly (Figure 7.1). These
screws are captive (held to the dome cover) and should not be removed from
the dome cover trim ring.
2. Lift the dome trim ring with shroud away from the camera assembly.
8 Mounting the Enclosure, Camera, and Lens Assembly
Mounting to masonry or other durable surface wall, ceiling or overhang
with cables routing through the wall or ceiling.
1. Select an appropriate position for the camera and drill the mounting holes and
cable pass through hole.
2. Route the network cable through the wall.
3. Gently push the Ethernet cable through the gasket installed in the enclosure.
Pull enough cable through the gasket to attach an RJ-45 network connector,
and to allow the network connector to plug into the Ethernet socket
(Figure 8.1).
It may be necessary to pierce a hole in the gasket with an Awl tool (not supplied).
NOTE:
• Do not cut the gasket with a knife.
• Do not force the Ethernet cable with connector through the gasket.
• Only pass one cable through the supplied gasket.
Figure 8.1
Figure7.1
Figure 8.2
