Wiring
Once the camera is secured into the housing, the wiring is done.
1.
Locate the white and green wires that are on the small day/night mode board mounted in the
housing.
2.
The white wire is Alarm In and the green wire is GND (ground; be sure to use the GND for
the ALM connection). Insert the pre-tinned wires into the correct round hole on the push-in
terminal connector of the camera. Refer to figure below. The square hole is used to release
the wire if necessary with the tool provided with the camera.
3.
Connect one end of the 1 foot CAT5 cable provided into the RJ-45 connector on the camera
and the other into the RJ-45 connector in the housing.
Camera Setup
1.
From the camera setup screen, advanced menu, be sure to set the Day Night Settings Mode
to day on trigger open; the default is auto.
PoE IN from external
PoE OUT to camera
12V DC OUT
12V power to the
