Copyright © 2017 Vicon Industries Inc. All rights reserved.
Product specifications subject to change without notice.
Vicon and its logo are registered trademarks of Vicon Industries Inc.
VICON INDUSTRIES INC.,
TEL: 631-952-2288 FAX: 631-951-2288 TOLL FREE: 800-645-9116
24-Hour Technical Support: 800-34-VICON (800-348-4266)
UK: +44 (0) 1489 566300 WEB: www.vicon-security.com
Vicon part number 8009-8278-80-00 Rev 517
This sheet will guide you through the process of installing the IQB9 camera into the H100-POE
housing. There are two types of installations; one for a camera with an integral lens and one for a
camera with no lens and a lens will be installed onto the camera. This process assumes you have the
proper components and hardware for the installation.
This system should only be installed by a qualified technician using common hand tools and
approved materials in accordance with the National Electrical Code ANSI/NFPA 70, state and local
wiring codes. It would be convenient to have the camera manual and the housing manual available
as reference if needed.
Installation
Camera with Integral Lens
1.
Open the camera housing using the Allen key provided. The housing will have a small
day/night mode board pre-mounted into the housing.
2.
Remove the front cap on the camera by loosening the thumbscrew to expose the lens.
3.
Remove the camera mounting plate from the H100-POE housing by removing the four (4)
screws.
4.
Mount the camera to the mounting plate through the slot in the plate using the ¼-20 screw
and washer provided. The camera has two mounting holes. Be sure to orient the camera
correctly so that the notch for the thumbscrew is on the top; otherwise the video will be
upside-down. The mounting plate should abut the indentation on the camera’s body.
5.
Insert the camera mounting assembly into the housing, nosing the camera end in first
towards the window; the camera lens should be as close to the window as possible. Secure
the mounting plate assembly back into the housing using the previously removed screws and
washers provided.
6.
Proceed to Wiring section.
Camera without Lens
1.
Open the camera housing using the Allen key provided. The housing will have a small
day/night mode board pre-mounted into the housing.
2.
Install the lens onto the camera according to instructions for the lens and/or camera.
3.
Remove the camera mounting plate from the H100-POE housing by removing the four (4)
screws.
4.
Mounting the camera to the mounting plate requires using a spacer plate. Be sure to orient
the spacer with the first guide pin facing the back of the camera. Mount the camera to the
mounting plate through the slot in the plate using the ¼-20 screw and washer provided. Be
sure the camera is at the wider end of the mounting plate. The camera has two mounting
holes. Be sure to orient the camera correctly so that the lens connector is on top; otherwise
the video will be upside-down. The mounting plate should abut the indentation on the
camera’s body.
5.
Insert the camera mounting assembly into the housing, nosing the camera end in first
towards the window; the camera lens should be as close to the window as possible. Secure
the mounting plate assembly back into the housing using the previously removed screws and
washers provided.
6.
Proceed to Wiring section.
