Vicon Cruiser SN660V, Инструкция по установке и эксплуатации

Страница: 17 / 86

11
6. Select “ START ANGLE ”. Press the Open IRIS key; the “CTRL” displays. Move to the desired
position and the zoom position. Press the Close IRIS key; the “CTRL” disappears. To adjust
at the 0.1 degree interval, ZOOM In/Out Joystick at the pan field and the tilt field. To adjust at
the one zoom interval, ZOOM In/Out Joystick at the zoom field.
7. Select “ END ANGLE ”. Press the Open IRIS key; the “CTRL” displays. Move to the desired
position and the zoom position. Press the Close IRIS key; the “CTRL” disappears. To adjust
at the 0.1 degree interval, ZOOM In/Out Joystick at the pan field and the tilt field. To adjust at
the one zoom interval, ZOOM In/Out Joystick at the zoom field.
8. Set “ SCAN DIR ” to CCW or CW.
9. Select “ SWAP ”; set to ON to exchange the start angle and the end angle.
10. Set “ DWELL TIME ”.
11. Select “ SAVE AND EXIT ” and push the Joystick to the right or press the Open IRIS key.
Press the Close IRIS key to exit the program without saving.
To set the position using the Preset position:
a. Before entering the Auto Scan menu, select a Preset position as a starting point for Auto Scan.
Example
:
P2P keys and do steps 1 to 5. In step 6, just press the Open IRIS key at the start
angle position; the current position will be displayed as a start position.
b. Press Close IRIS to Save and Exit from the menu.
Press the P60P key on the angle field to display with the small OSD. Then the screen will display
as below.
AUTO SCAN AREA SETUP
(CTRL KEY)
NUMBER01
START : ----- -----
END : ----- -----
EXIT(ESC TO EXIT)
The setting procedure is the same as above.
NOTE: 09: AUTO-PAN mode (endless panning/continuous rotation)