B E Y O N D M O T I O N
1
mailto:[email protected]
Page 4
Active Wand v2
1.
2.
3.
1.
2.
3.
4.
5.
6.
7.
8.
Charge the Active Wand battery
To charge the battery:
Plug in the supplied Active Wand battery
charger.
Insert the charger connector into the Active
Wand and leave it to charge.
Note that a full recharge takes approximately
four hours.
When the battery is fully charged, indicated by
five green LEDs, detach the charger.
The green battery charge indicator LEDs remain
illuminated for about 10 seconds.
Replacing the Active Wand battery
To replace the Active Wand battery:
Remove the screws from the handle.
To reveal the battery, detach the back of the
handle.
Unplug the battery connector
.
Remove the old battery
.
Place the new battery into the battery holder.
Attach the battery connector.
Replace the Active Wand handle and screws.
Turn on the Active Wand, run it in Continuous
mode until the battery is flat, then
.
This enables the Active Wand to calculate the
battery life.
Caution
To prevent damage to the Active Wand, use
only the supplied charger.
•
•
•
•
•
Warning
This product contains a lithium ion battery.
Do not incinerate the battery.
Do not disassemble the battery.
Do not short the battery terminals.
Do not expose the product or the battery to
high temperatures (140°F/60°C).
As the battery is subject to shipping
regulations, use only the original packaging to
ship the unit. For further shipping instructions,
contact Vicon.
Warning
Before replacing the battery, turn off the Active
Wand.
Note
To order additional batteries, contact
Due to current shipping regulations, which do not
permit shipment of lone lithium ion batteries, you
will be asked to return your wand. Vicon will then
fit a new battery before shipping your wand back
to you.
