Vicmarc Machinery VL150 BM, Руководство пользователя

Страница: 10 / 32

®
P10
LATHES
9.1 Spindle Pulley Speeds
It is important that the belt is on the right pulley for the speed required. Not doing so can cause the motor to
overheat. Below is a representation of the headstock pulleys and their equivalent ratio’s.
6-speed spindle step pulley
(Based on a 1500rpm motor)
Maximum speed for the
three step pulley
9.2 Setting up the Tailstock
The eccentric locking mechanism of the tailstock is factory
preset. If adjusting is necessary the following steps are
applicable:

Slide tailstock to the end of the bed as illustrated.

Undo the M10 locking nut item 14 (clockwise is loosening
and anticlockwise is tightening) with an 16mm open end
spanner, then rotate the clamping plate clockwise to
tighten.

Lock the Tail stock with locking lever, if lever is in
the correct position is at eleven o’clock Re-lock the
locking nut.

The tailstock lever can be swapped to the opposite side
of the tailstock if preferred. Simply remove the circlip
and reposition the bush and tailstock locking lever to the
opposite side.
9.3 Setting up the Camlock
The eccentric locking mechanism of the Camlock is factory
preset. If adjusting is necessary the following steps are
applicable:

Remove Tailstock than slide Camlock to the end of
the bed as illustrated.

Undo the M10 locking nut item 7 (clockwise is
loosening and anticlockwise is tightening) with an
16mm open end spanner, then rotate the clamping
plate clockwise to tighten.

Lock the Camlock with locking lever, if lever is in the
correct position is at four or eight o clock, re-lock
the locking nut. (Camlock is designed to lock in both
directions)
9.4 Mounting and Removing the Chuck
Mounting
Before mounting the chuck, make sure that the threads
are clean and free of grit.

Place the tommy bar (supplied with Vicmarc
®
Chuck)
into the spindle to hold it in place.

Mount the chuck on the lathe, carefully place the chuck
on the thread, making sure it is square.

Turn the chuck slowly to screw on the chuck until it is tight.

The machine should never be turned on for this procedure.
9. LATHE VL150
12
13
14
5
6
7
600 960
1170 1780 2160 3630
9.
V
L1
50
L
AT
H
E
1175
(1:
2.
5)
2470
(1:
1.
2)
3500
(1.
2:
1)
Pulley Ratio
Readout 1.2:1 1:1.2 1:2.5
3000 3500 2470 1175
2500 2917 2058 979
2000 2333 1647 783
1500 1750 1235 588
1000 1167 823 392
500 583 412 196
250 292 206 98
100 117 82 39
30 35 25 12