Vibe LiteAir LA4, Инструкция по эксплуатации

Страница: 4 / 8

TWEETER INSTALLATION
The tweeter can either be fi tted fl ush mount or surface mount. Try and take into account the following
when locating a suitable position. For optimum staging try and locate a position that is higher than
the woofer but within twelve inches (maximum) of it.
It is vital that the tweeter is adjusted so that it is focused towards the listener.
SURFACE MOUNT TWEETER INSTALLATION
• After fi nding a suitable position for the tweeters place the base of the tweeter casing in the correct
position.
• Using this base mark the two mounting holes and the hole for the wire to pass through.
• Cut out these holes using a 2mm drill for the fi xing screws and at least an 8mm hole for the cable,
ensuring that the hole cut for the cable is big enough and will not cause the cable to become
chaffed in any way.
• Pass the tweeter cable through the bottom of the case and through the previously drilled hole.
• Secure the bass of the tweeter housing with the screws provided.
• Finally, angle the tweeter so that it is focused towards the listener.
FLUSH MOUNT TWEETER INSTALLATION
For ease of installation there are two ways of fi xing the tweeters in place.
The fi rst requires the use of the metal ring provided. ( See Figure A )
• After fi nding a suitable position for the tweeters place the cut out template for the tweeter in position
and mark around it.
• Before cutting the holes double check that no brake, fuel lines or wiring harnesses are likely to get
damaged.
• Ensure that the tweeter when fi tted will not catch on any moving parts such as door / window
handles.
• If mounting in a door check that the window can still be fully lowered before installing.
• Cut out the hole carefully.
• Place the entire tweeter into the cut out hole.
• From the back push the metal ring over the rear of the casing until it is tight into the hole.
4
LiteAir Component Speakers