Vibe BlackDeath 15 SPL, Инструкция по эксплуатации

Страница: 3 / 8

RUN IN PRO R R CEDURE
VIBE recommends that you follow the run in procedure for the subwoofer detailed below.
When your subwoofer is used for the first time it is very stiffff and rigid, it will take time for the moving
parts of this subwoofer to loosen up before the subwoofer will be ready to deliver its full potential.
For the first 30 hours it is recommended that you play the subwoofer initially at low to medium
volumes, gradually increasing the volume level as time progresses.
As a guide, if you listen to your subwoofer for 1 hour every day it will take a month for the speaker
to run in properly. You
Y Y will notice a big change in the sound of the subwoofer over this period, as
the spider and surround begin to run in the sound will get deeper and harder, also the output of the
subwoofer will increase as the suspension loosens up.
A new subwoofer is like a new car engine, it needs a few thousand miles before you can drive it to
its full potential, driving it into the ‘red line’ from the first day will mean engine damage is certain and
will not be covered by warranty and the same applies to the subwoofer. Failure to follow this simple
procedure is the most common reason for a subwoofer to fail after a very short period of time.
WIRING OPTIONS
The BLACKDEATH subwoofer has a quad 1 Ÿ voice coil, four or more amplifiers may be connected
to the BLACKDEATH subwoofer, below is a few different wiring examples, please check with your
amplifi er manufacturer as to which wiring method is most suitable.
1 Ÿ 4 Ÿ 2 Ÿ
1.5 Ÿ
Ÿ Series / Parallel 4 Ÿ Mono Series 2 x 2 Ÿ Series
BlackDeath 15 SPL ‘Bubonic’ Subwoofer
3