Vibe BASS 1, Инструкция по эксплуатации, Страница: 4 / 16

1
10 11
12
2 3 4 5 6 7 8
9
Connections and Controls - BlackBox Stereo 2
1. High Level Input
To be used when no RCA's are available. Use the provided loom to connect to closest speakers. The loom connector will only
fit one way around. Once plugged in you should connect the wires as below:
2. Low Level Input / Output
Low level input connection to any source (head unit) with a low level output. This is your RCA output from the source
(headunit)
Low level output is a daisy chain RCA connection to allow easy addition of another amplifier.
3. Gain Control
Used to match the input signal of the source to the amplifier. See the setup section for more details.
4. Bass Boost Switch
To provide up to an extra +24 dB of bass boost at 45 Hz. Use this boost to Increase bass output from the amplifier.
5. Low Pass Crossover Control
The control is used to select the low pass filter frequency. The frequency ranges are from 30 Hz to 300 Hz.
6. Crossover Control Switch
This switch is used to select high pass, low pass or full (no crossover) operation for the amplifier speaker outputs.
7. High Pass Crossover Control
The control is used to select the high pass filter frequency. The frequency ranges are from 50 Hz to 1KHz.