4
EN
CONNECTION AND ASSEMBLY
INSTRUCTIONS
●
Screw the 2 threaded tip bars into the rear panel
of the main body and fit the methacrylate plate for
accessory support.
●
Connect the power cable to the rear panel of the
main body.
●
Connect the face handpiece connector to the rear
panel of the main body.
●
Connect the body handpiece connector to the rear
panel of the main body.
●
Connect the negative electrode plate connector to
the rear panel of the main body.
●
Place the handpieces, negative electrode plate
and heads on the methacrylate plate for accessory
support.
POWER AND CONFIGURATION
●
Press the on/off button to start the device. When
it is on, a beep will sound and the welcome screen
will be displayed.
-
Press the screen to move to the next display
screen and the parameter control.
●
The preset values when switching on the device are
as follows:
-
Selection of function to use: face
-
Length of treatment: 30 minutes
-
Operating mode: A
-
Intensity level: 1
●
Set the previous parameters
-
Selection of function to use: face / body
-
Length of treatment: maximum 60 minutes
-
Operating mode: A, B
-
Intensity level: 1 - 10
-
Definition of preset modes:
• Mode A: Continuous wave
• Mode B: Pulsed wave
●
Performing the treatment:
-
Apply cream for radiofrequency use across the
area to be treated.
-
Insert the appropriate head into the
corresponding handpiece according to the area
to be treated.
-
Select the function to use: body or face.
-
Set the length of treatment.
-
Select the work mode: A or B.
-
Set the intensity level to minimum.
-
Place the negative electrode plate in such a way
that there is good contact with the person who
is going to receive the treatment. If this person is
lying face up on a bed, you can place it on their
back.
-
Start moving around the handpiece and set the
intensity level according to the treatment to be
performed.
Remember:
Massage with continuous circular movements. Do
not stop the massage and avoid leaving the head in
contact with the skin at the same point: the user could
suffer burns.
Ask the user of the radiofrequency treatment how they
are perceiving the sensation of heat applied. Set the
intensity level according to their perception.
Apply enough cream for radiofrequency use as many
times as necessary during treatment.
CLEANING AND MAINTENANCE
●
Before cleaning the device, unplug it from the
mains.
●
Clean the device with a soft, dry cloth. Do not use
liquids to clean it.
●
After each use, the various components and
accessories must be sterilised and left to dry.
●
For maintenance or repairs of any part of the
product, please contact your distributor or
specialised technician.
RECYCLING
If you need to dispose of the product or any of its
parts or accessories, please check and respect the
laws and regulations applicable to waste management
and environmental protection.
