Viavi Xgig, Руководство пользователя

Страница: 357 / 468

Using the Traffic Summary Pane Chapter 14, Using the Secondary Panes in Xgig TraceView
Xgig Analyzer User’s Guide 343
Traffic Summary SAS/SATA Error Counters
The following table describes the error counters found by the hardware that are counted in the
Traffic Summary pane.
Table 30: Traffic Summary SAS/SATA Error Counters
Error Counter Description
Errors Found by Hardware A summary count of all errors below. If multiple errors occur on a
single event, it is only counted once by this counter.
Code or Disparity Error Counts all occurrences where a code violation or disparity error is
detected by the hardware.
CRC Error Counts all CRC errors.
Framing Error Counts all occurrences where a frame is abnormally terminated or an
EOF is found outside of a frame.
Loss of Sync Counts all occurrences where there is a Loss of Sync or Loss of
Signal.
Primitive Error Counts all occurrences where a Dword is detected that has a K
character but is not a standard primitive.
Primitive Sequence Error Counts all occurrences where a Primitive Sequence is malformed.
Connection Conflict Counts open collisions when both channels see OPEN address
frames at the same time.
Multiplexing Alignment Error Increments when a multiplexing alignment error occurs. These errors
can occur only when the signal through the port contains two logical
channels. Every other Dword on the physical port must belong to a
single logical channel.