Viavi T-BERD MTS 5800, Руководство по началу работы

Страница: 56 / 296

Chapter 2 Assembling Your Instrument
Connecting a DMC to a base unit
T-BERD/MTS/SC Getting Started Guide
Page 32 22046537, Rev. 016 March 2018
5 Starting at the upper right corner, do the following:
a Using the hex key that you removed from the battery module, tighten screws
1 through 4 (in the sequence illustrated in
Figure 23 ) until you feel a slight
resistance. The same sequence is used when attaching a DMC.
b After all four screws are tightened, using the hex key, tighten each screw at
least one additional quarter-turn in the sequence illustrated in
Figure 23 .
6 After the DMC is secured to the base unit, put the hex key back in the battery
module, and then do the following:
a Position the battery module over the DMC, with the battery module’s mating
connector directly over the mating connector on the DMC.
b Verify that the holes on each corner of the battery module are aligned
precisely with the holes on each corner of the DMC.
c IMPORTANT: Verify that you are holding the battery module in a position
parallel to the DMC. If the module is tilted at even a slight angle, the mating
connectors may not connect properly.
7 Slowly lower the battery module until it is just over the holes on the DMC, and
then gently but firmly press the center of the battery module to attach it to the
DMC.
8 Starting at the upper right corner, do the following:
a Using the large flat blade screwdriver, tighten screws 1 through 4 until you
feel a slight resistance. Use the same sequence illustrated for the DMC
screws in
Figure 23 .
b After all four screws are tightened, tighten each screw at least one additional
quarter-turn.
Figure 23 Sequence for securing and tightening the screws
1
2
3
4