Viavi T-BERD MTS 5800, Руководство по началу работы

Страница: 43 / 296

Chapter 1 Overview
About the MSAM Assembly
T-BERD/MTS/SC Getting Started Guide
March 2018 22046561, Rev. 016 Page 19
MSAM chassis
Each MSAM chassis provides the application module software, one or two PIM ports,
and a 75 OHM BNC connector (used for external timing). Several types of chassis are
available; therefore, your unit may not have both of the ports illustrated in
Figure 12 .
Table 7 lists the available MSAM chassis.
Figure 12 MSAM chassis (dual port with XFP and SFP PIMs)
NOTE:
The MSAMv2 chassis has an additional USB host connector to the right of Port
2 and the BNC EXT REF connector is replaced with a SMA CLK I/O connector.
Table 7 MSAM chassis
Catalog
Number
Description
C0400 Single Port 1.544 Mbps to 4 Gbps
C0400-v2 Single Port 1.544 Mbps to 10 Gbps
C0404 Dual Port
1
1. A dual port chassis is required if you intend to use the MSAM for OTN testing.
1.544 Mbps to 4 Gbps
C0404-v2 Dual Port 1.544 Mbps to 6 Gbps
C1000 Single Port 1.544 Mbps to 10 Gigabit
C1000LB Single Port 10 Mbps to 10 Gbps Loopback Only
C1004 Dual Port
1
– One 1.544 Mbps to 10 Gbps port
– One 1.544 Mbps to 4 Gbps port
C1010-v2 Dual Port 1.544 Mbps to 10 Gbps
MSAM chassis
BNC connector
SFP PIM with two
transceiver cages
XFP PIM with one
transceiver cage