Page
18
of
23
9.2 Setting an input source for a zone
To allocate a certain input signal to a zone, the following operating steps must be accomplished:
1) selecting the input signal:
for this purpose the „IN“ key has to be pushed/confirmed until the LED line „IN“ shows the required
input-number.
2) selecting the target zone:
for this purpose the „OUT“ key has to be pushed/confirmed until the LED line „OUT“ shows the
required zone number.
3) confirming the selection (input signal/target zone):
for this purpose the „ROUTING“ key has to be pressed. This key works after the toggle principle:
pressing the key several times changes the status between:
- tieding the preselectet output / input
- untieding the preselectet output / input
9.3 Setting the volumne for a zone
To set the volume for a zone, the following operating steps must be accomplished:
1) Selecting the target zone:
for this purpose the „OUT“ key needs to be pressed until the LED line „Out“ shows the required zone
number.
2) Setting the volume:
for this purpose the keys „“ and „VOLUME-„ need to be pressed. Accordingly to which key
is being used, the volume changes in the before selected zone. The currently set value will be shown
in the LED line „IN“.
9.4 Setting the tone control for a zone (bass control)
To adjust the bass for a zone, the following operation steps must be accomplished:
1) Selecting the target zone:
for this purpose the „OUT“ key needs to be pressed until the LED line „Out“ shows the required zone
number.
2) Adjusting the bass:
f
or this purpose the keys „BASS+“ and „BASS-„ need to be pressed. Accordingly to which key is
being used, the volume changes in the before selected zone. The currently set value will be shown
in the LED line „IN“.
9.5 Setting the tone control for a zone (treble control)
To adjust the trebels for a zone, the following operation steps must be accomplished:
1) Selecting the target zone:
for this purpose the „OUT“ key needs to be pressed until the LED line „Out“ shows the required zone
number.
2) Adjusting the trebels:
for this purpose the keys „“ and „TREBLE-„ need to be pressed. Accordingly to which key
is being used, the treble changes in the before selected zone. The currently set value will be shown
in the LED line „IN“.
