Viatek LL03-RG-MOV-R, Инструкции

Страница: 3 / 4

Activating Remote
Pull the strip from the battery compartment on the back of the remote. To
test the remote’s battery connection, press any button and the LED will
illuminate for 1 second. If the LED does not illuminate, open the battery
compartment to make sure battery is properly installed.
Assembly
Screw the stake into the bottom of the light projector clockwise until tight
(fig. 1). To adjust the angle of the light projector, loosen the pivot clamp
screw by turning it counterclockwise. Once the angle adjustment is made,
twist the pivot clamp screw clockwise until
tight to secure (fig. 2).
Plug the 2-prong adapter into the power
supply transformer. Screw on the weather-
resistant cap tightly to help protect the
connection from weather.
IMPORTANT: Point Night Stars directly at
your home and never point Night Stars directly into the sky. Do not
project Night Stars at or within the flight path of an aircraft within 10
nautical miles of an airport. If the surface at which you intend to point
the Night Stars laser is within 10 nautical miles of an airport, lower
the angle so that it does not point into the sky. Do not point laser light
toward oncoming pedestrians, vehicles, or traffic routes on land, sea, or air.
Operation
Press the button on the back of the laser unit to set motion speed or
turn off. Settings are fast, medium, slow, still, and off. Pressing this button also clears flash settings.
See the below chart for remote operations. The remote can be used hand-held or mounted to a
surface.
COLOR
FLASH
2H
8H 6H
4H
RESET
Motion Speed
4 settings: still, slow, medium, fast
Change Light Color
Choose red, green, or dual-colored light
(Clears flash setting)
Reset
Cancels timer settings
6-Hour Timer
Sets the unit on a 6-hour on,
18-hour off daily cycle
8-Hour Timer
Sets the unit on an 8-hour on,
16-hour off daily cycle
2-Hour Timer
Sets the unit on a 2-hour on,
22-hour off daily cycle
4-Hour Timer
Sets the unit on a 4-hour on,
20-hour off daily cycle
Light On/Off
Press On/Off while unit is plugged in and
remote will connect to unit within 5 seconds
Flash Setting
Toggle between flashing
or steady light
Fig. 1
Fig. 2
IF REMOTE IS NOT CONTROLLING THE LASER
while you are within remote control range,
and if the remote LED comes on when you press the buttons, your remote may not be synced with the laser
light. In this case, follow these syncing instructions:
Syncing the Remote:
Be sure you are within 5 ft. of laser to sync. Do not use an extension cord during syncing process.
1. Remove the battery from the remote, then reinstall battery. This resets the remote.
2. Unplug the laser from the power source and wait 1 minute. This resets the laser.
3. With remote in hand, plug laser into wall outlet. QUICKLY, BEFORE 3 SECONDS PASS, press the
ON/OFF button on remote AFTER plugging the laser in. DO NOT press the ON/OFF button at the same
time you plug in, it must be done within 3 seconds AFTER plugging in. DO NOT hold the button down.
Do not use an extension cord during syncing process. Once the laser is synced, it may be unplugged
and used with an extension cord. Occasionally, re-syncing the remote with the laser may be necessary. In
this case, repeat the steps above. To sync two or more lights to the same remote, unplug them all, then
plug them back in at the same time. AFTER plugging them in, press the ON/OFF button within 3 seconds.
Remove remote battery before long-term storage.
Range: Up to 11 yards