11
d). I
mage pan rotation angle setup. Please refer to Figure 3-8 to turn lock screw D to adjust
the video pan angle. Then fix the lock screw B and C. The video pan angle ranges from
0°~+350°.
Figure 3-8
e) For the manual varifocal series product, please skip current step. Please refer to chapter
3.2.2 for the lens zoom and focus operation of the manual focus series product.
f) For the IR series product, please skip current step and complete the angle setup directly.
For the non-IR series product, please put back the black plastic decoration enclosure to
complete the angle setup.
Important
Please note Figure 3-7 and Figure 3-8 is based on the IR manual varifocal camera. For
the non-IR series product, the lock screw position and the lens angle adjustment are the
same.
Step 7
Line up the dome camera protection enclosure to the cable exit on the side panel. Put the
enclosure back and then use the inner hex wrench to secure the 3 inner hex screws firmly.
Now the installation is complete.
Note
Usually we recommend, after the installation, please take the three white static protection
gaskets from the accessories bag and insert them to the screw holes of the protection
enclosure. It is to enhance device reliability.
3.2.2 Manual Varifocal Lens Operation
The manual varifocal lens interface is shown as in Figure 3-9.
Step 1
Slightly loosen the adjusting screw E and push the adjust screw E to make it swing. Adjust the
lens focus to the proper position according to the displayed video.
Lock screw B/C
Adjust lens tilt rotation
angle.
Lock screw D
Adjust lend pan rotation
angle.
