Viali VGGDW60W, Инструкция по эксплуатации

Страница: 26 / 40

25
Turning on the Dishwasher
Starting a Wash Program
1. Draw out the lower and upper basket, load the dishes and push them back in.
2. It is recommended to load the lower basket first, then the upper one
3. Pour in the detergent (see page 17)
4. Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the
specification of the socket is 10A 250VAC.
5. Make sure that the water supply tap is turned on to full pressure.
6. Close the door then press the ON/OFF button to switch on the machine.
7. Press the program button, the wash program will be changed as follows: Normal-
>Glass->90 min->Rapid->Intensive->Heavy; if a program is selected, the
response light will light. Then press the Start/Pause button, the dishwasher will
begin to start.
Changing the Program
1. A cycle that is underway can only be changed within a short period of time.
Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water. If this is the case and the program is changed,
the detergent dispenser must be refilled (see page 17).
2. Press the Start/Pause button, the machine will be in standby state. Then press the
program button for more than 3 seconds then change the program to the desired
cycle setting (see the section entitled “Starting a Wash Program”)
IMPORTANT if you open the door while the appliance is washing, the machine will pause. The
program will stop blinking and the buzzer will sound every minute, unless the door is closed.
After you close the door, the machine will continue to run after 10 seconds.