INSTALLATION INSTRUCTIONS:
CHECK FOR CORRECT ONBOARD AIR HOOKUP KIT:
Onboard Air Hookup Kits have been
designed for use with our 200, 300, and 400 series compressors. Please make sure that you have
the correct kit for use with your specific model compressor.
For Onboard Air Hookup to compressors or systems other than VIAIR components, refer to following
chart:
IMPORTANT:
The Illuminated Dash Panel Gauge has been fully function tested and calibrated for accuracy.
The air inlet on this gauge has a factory installed compression fitting. DO NOT attempt to
tighten or loosen the body of this compression fitting. Any adjustments will likely cause the
gauge to malfunction and void warranty. (See. Fig. 1)
NOTE:
The Dash Panel Gauge included in this kit is rated for 150 PSI. Do not pressurize gauge over
150 PSI. Over-pressurization will cause the gauge to malfunction and will void your product warranty.
Compressor
Max. Amp Draw/Pressure Switch Cut-out Pressure
30 amp / 110PSI ON, 150 PSI OFF
Part No. 20052
Part No. 20053
Part No. 20055
30 amp / 85 PSI ON, 105 PSI OFF
30 amp / 90PSI ON, 120 PSI OFF
VIAIR
Onboard Air Hookup Kit
