ViaAqua In-Sump Skimmer 2 SK-200NW, Руководство пользователя

Страница: 9 / 12

7
MAINTENANCE
VIAAQUA
®
WATER PUMP AND VENTURI
1. Disconnect the pump from the electrical outlet.
2. Remove the skimmer from the sump.
3. Remove all the water from the skimmer’s main body.
4. Remove the venturi intake tube and air control valve. This will run water
through the unit so that water runs through air control valve remove all
salt deposits.
5. Remove the impeller well cover.
6. Remove the impeller and the shaft, clean well. A small amount of vinegar
should be used to clean the ceramic shaft. Soak shaft in a 1 part vinegar to 3
parts water soluation for 30 minutes.
7. Clean the inside of the impeller well with a small brush.
8. Reassemble and install the unit back into the sump.
DISCHARGE SPONGE
•
If sponge clogs, the water level in the skimmer will increase and cause the
skimmer to collect wetter foam/water in the collection cup. In a new tank it
may be necessary to clean the sponge every week.
Replace sponge as needed.
COLLECTION CUP
•
Clean as often as needed. At times the collection cup may have to be cleaned
everyday. Keeping the collection cup clean ensures a properly
operating skimmer.
MAIN BODY
1. Disconnect the pump from the electrical outlet.
2. Remove the skimmer from the sump.
3. Remove all the water from the skimmer body.
4. Disconnect the U/D mixing chamber.
5. Remove the pump from the skimmer body.
6. Fill unit with water and add a small amount of bleach.
Approximately one capful.
7. Let stand for one hour.
8. Rinse unit well and refill with fresh water.
9. Add a water conditioner that removes chlorine to the water and let stand
for one hour.
10. Rinse well, reassemble and install.