1
2
Drip
Loop
GFCI
ONLY
• Built-in water pump and bleed valve
• Built-in compression fitting for pH sensor
• Use in sump or hanging pump
ViaAqua® Acro-Cal
TM
Calcium Reactor offers a simple and convenient solution for
maintaining calcium and alkalinity in your reef tank. After the initial setup, the calcium reactor
requires minimal maintenance. A calcium reactor is almost a necessity for tanks heavily
stocked with stony coral, where calcium and alkalinity demands are high and will promote
coral line algae growth. Acro-Cal
TM
Calcium Reactor provides a steady supply of calcium by
using CO
2
to dissolve media in the reactor and, thus, releasing calcium into your water. The
effluent released also acts as a buffer to stabilize kH.
WARNING AND SAFEGUARDS:
This product may contain chemicals known to the state of California
to cause cancer and or birth defects or other reproductive harm.
Wash your hand after handling this product.
It is your sole responsibilities to verify that the plug and the
receptacle are clean and free of moisture and salt build up at
all times. The receptacle must be free of water, salt, calcium,
magnesium and dust. Failure to do so can cause fire, damage to
property, permanent damage to the product and personal injury not
limited to loss of life.
Do not plug into extension cord/power strip.
A drip loop must be used when plugging all electrical aquarium
devices. A drip loop is that part of the cord hanging below
the receptacle.
The national code requires that a GFCI (Ground fault circuit
interrupter) be used in the branch circuit supplying all power
to water pumps and electrical aquarium equipment. If you
do not have a GFCI, have an electrician install one prior to
operating any aquarium component.
• Read and follow all instructions before using the Acro-Cal
TM
Reactor to ensure proper use
and application.
• Use this product for its intended use only.
• Do not operate ViaAqua® Acro-Cal
TM
Reactor without water. Doing so can cause permanent
damage to the pump.
• Prior to maintenance on any electrical aquarium appliance or aquarium, you must disconnect
all electrical aquarium devices.
• Routine maintenance is required to ensure the maximum performance and the longevity of
the ViaAqua® Acro-Cal
TM
Reactor. See maintenance guidelines.
• The use of a surge suppressor is strongly recommended.
Items Required for Installation (not included):
• CO
2
Source
• CO
2
Regulator
• CO
2
Check Valve
• Silicone Tubing
• Oceanpure™ Calcium Reactor Media
• pH Controller (recommended)
• Lid secured with latches
• Bubble counter included
• For 50 to 200 gallons aquariums
PART LIST
1. Latch
2. Hanger
3. Support grid
4. Sponge
5. Stand pipe
6. Suction cup bracket
7. Base
8. Bubble counter