VIA Technologies, Inc.
VIA Technologies, Inc.
VIA Technologies, Inc.
VIA Technologies, Inc.
1F, 531, Zhong-Zheng Road,
Xindian, Taipei 23148
Taiwan
Tel: 886-2-2218-5452
Fax: 886-2-2218-5453
Web: www.via.com.tw
Copyright © 2009 VIA Technologies, Inc. All rights reserved.
For more information on this and
other VIA products, please visit
www.viaembedded.com.
For further support and service,
please visit www.via.com/tw/en/
products/mainboards/contact.jsp
The WiFi kit should include the WiFi module, two screws, one board-
to-board cable, one mini coaxial cable, one washer, one nut, and one
external antenna.
The optional WLAN module includes a VT6656 WLAN controller and
provides support for 802.11 b/g standards.
Layout
Layout
Layout
Layout
The Bluetooth kit should include the Bluetooth module, one screw, and
one board-to-board cable.
The optional Bluetooth module includes a printed antenna and uses
the Qcom QBT400UB 01P Bluetooth controller. The Bluetooth module
is classified as a Class 2 device with an effective range of 10 meters. It
supports multi-point operation and a full 7-slave piconet.
Dimensions
Dimensions
Dimensions
Dimensions
Pinouts
Pinouts
Pinouts
Pinouts
Pin
Pin
Pin
Pin
Signal
Signal
Signal
Signal
Pin
Pin
Pin
Pin
Signal
Signal
Signal
Signal
1
LINE_OUT_R
2
LINE_OUT_L
3
LINE_IN_R
4
LINE_IN_L
5
MIC_R_R
6
MIC_R_L
7
KEY
8
NC
9
AGND
10
AGND
JAUDIO1
Pi n
Pi n
Pi n
Pi n
Signal
Signal
Signal
Signal
1
W_LESS_LED
2
GND
JWLESS-LED1
3
3
3
3
Installing the
WiFi module
4
4
4
4
Installing the
Bluetooth module
Step 4
Step 4
Step 4
Step 4
Insert the large end of the mini coaxial cable into the front face plate.
Secure it in place by inserting the washer and then locking the washer
in place with the nut.
Step 5
Step 5
Step 5
Step 5
The external antenna can be attached to the antenna connector on the
faceplate.
Step 1
Step 1
Step 1
Step 1
Align the mounting holes and secure the module to the EMIO-3430.
Step 2
Step 2
Step 2
Step 2
Then insert the board-to-board cable with the contacts facing down
into the connectors as shown in the picture.
Step 3
Step 3
Step 3
Step 3
Connect the mini coaxial cable to the mini RF connector.
Step 1
Step 1
Step 1
Step 1
Connect the board-to-board cable from the module to the EMIO-3430.
Ensure that the contacts on the cable are facing down before inserting.
Step 2
Step 2
Step 2
Step 2
Align the mounting holes and secure the Bluetooth module to the
EMIO-3430.
Pin
Pin
Pin
Pin
Signal
Signal
Signal
Signal
1
BT_LED
2
GND
JBT-LED1
Step 4
Step 4
Step 4
Step 4
The external antenna can be attached to the antenna connector on the
faceplate.
Step 3
Step 3
Step 3
Step 3
Attach the small end of the mini coaxial cable to the mini RF connector
on the GPS module.
