Step 1
Align the EMIO-3210 module with the spacers, and secure the module
to the spacers with the nine mounting screws. (M3*6mm). Then
connect the other end of LPT cable to pinhead connector.
5
4
3
Installing the
audio jack cable
Step 1
Insert the two audio jacks into the audio cutout. Then fasten the
audio jacks in place with the nuts respectively.
Step 2
Locate the audio pin header on the EITX-3000 board and gently
connect the other end of audio jack cable to the pin header.
Installing the WiFi
module (optional)
The WiFi kit should include the WiFi module, two screws, one board-
to-board cable, one mini coaxial cable, one washer, one nut, and one
external antenna. The optional WLAN module includes a VT6656
WLAN controller and provides support for 802.11 b/g standards.
Step 1
Flip the top cover and align the WLAN module over the WLAN
mounting holes.
Installing front , rear
and top plate
Step 2
Remove all standoff screws from the front and rear I/O connectors of
the EMIO-3210 module.
VIA Technologies, Inc.
1F, 531, Zhong-Zheng Road,
Xindian, Taipei 23148
Taiwan
Tel: 886-2-2218-5452
Fax: 886-2-2218-5453
Web: www.via.com.tw
Copyright © 2010 VIA Technologies, Inc. All rights reserved.
For more information on this and
other VIA products, please visit
www.viaembedded.com.
For further support and service,
please visit www.via.com/tw/en/
products/mainboards/contact.jsp
Step 2
Insert the WLAN port (with washer) into the antenna cutout and
fasten it with the nut. Then install the external antenna and connect
the mini coaxial cable to the mini RF connector onto WLAN module.
Step 3
Gently connect the WLAN board-to-board cable to the USB pin
header on the EITX-3000 board and to the mini connector on the
WLAN module.
Step 4
Align the top cover over the mounting holes on the heatsink. Then
secure the top cover with eight mounting screws.
Step 3
Align the front and rear I/O plates to the heatsink of the EITX-3000
board stacked with EMIO-3210 module. And reinstall all the standoff
screws (P/N: 99G44-030221) to the front and rear connectors.
Dimensions
2
Installing the
GPIO connector
Step 1
Insert the D-sub 9-pin GPIO connector into the GPIO cutout and
fasten the provided standoff screws to secure the connector.
Step 2
Locate the GPIO pin header on the EITX-3000 board and gently
connect the other end of GPIO cable to the pin header.
