3
Installation
1
.
SET-UP HOOP
a.
Adjust hoop to lowest setting. Instillation using a
ladder is not recommended.
2.
SENSOR BOX
a.
Locate area underneath backboard spring. Surface
needs to be dry and clear of debris.
b.
Remove 3M Dual-Lock Velcro adhesive seal from
back of Sensor Box.
c.
Battery case wire exits Sensor Box towards the
ground.
d.
Place Sensor Box on the surface located at least 5
millimeters under backboard spring.
e.
Ensure Sensor Box is out of reach of the ball.
f.
Press firmly for 30 seconds, to ensure 3M adhesive
bonds properly.
3
.
LED STRIP
a.
Use Zip Ties to secure
LED strip to the hook that
you weave the net
through under the rim.
b.
Secure tightly to avoid
abrasion.
c.
Clip off Zip Tie tails for best visual effect. Be careful
not to cut the net!
4.
BATTERY CASE
a.
Raise hoop before attaching battery case to avoid
wire damage.
b.
Tape the wire to the pole at the highest point.
Ensure wire is flush to the pole (see diagram).
*WARNING*
If you ever decide to adjust the hoop back
down make sure to remove the tape, to avoid wire damage.
Содержание HoopLight
Страница 2: ...2 Parts...
