VEXILAR 107 PRO, Руководство по эксплуатации

Страница: 11 / 32

Using an epoxy or silicone
glue, make a puddle about
the same diameter as the
transducer on the hull. Place
the transducer in the glue.
Press it down firmly, gently
twisting it back and forth,
making sure that there are no
air bubbles in the glue
between the transducer and
the hull. Let the glue dry completely before turning the unit
on.
TROLLING MOTOR MOUNTING
Use two hose clamps or large cable ties (not included)
to attach the transducer to an electric trolling motor. Using
the slots in the transducer, run the ties through them and
around the motors lower unit. Locate the transducer on the
bottom of the lower unit as in figure 10. Run the cable up
the shaft using smaller cable ties to hold it in position. Make
sure that the cable will not be
damaged by the movement of
the trolling motor. Plug the trans-
ducer connector into the back of
the unit and screw the retaining
ring down tight.
11
Figure 10