Clamp the bracket around the handlebars and tighten in place. All Vetta cycle computer brackets are designed
to work with 26.0 - 26.4mm standard diameter road handlebars. Shims are provided to fit smaller 25.4mm
mountain and road bars. Make sure not to over tighten the bracket as this may result in breakage. The
bracket only needs to be tightened enough to keep it from spinning on the handlebar during normal riding.
The heads of all Vetta computers are designed to lock into their brackets. When
installing your computer head into the bracket you should hear an audible
“SNAP”
indicating that the unit is locked firmly in place. The head of the C-06 will slide
into the bracket from the front to the back.
BRACKET INSTALLATION
HEAD UNIT INSTALLATION
Once you have finished with the installation procedure, you are ready to test the unit to make sure that it works.
STEP 1
Advance the computer to the speedometer mode.
STEP 2
Pick up the front of the bicycle and spin the front wheel. The computer should register speed within 1-2 seconds.
If you do not get a speed reading, check to be sure that the magnet and sensor alignment is correct and that
the space between the magnet and sensor is 1-2mm or less. If this does not solve the problem, call the Vetta
customer service hotline at 1.800.GO.VETTA.
TEST OF INSTALLATION