VETRON 5400, Инструкция по эксплуатации

Страница: 46 / 77

1
2
5
4
3
44
07/2020
VETRON 5400 - CYLINDER ARM MACHINE - INSTRUCTION BOOK
05. PROGRAMMING
04. PROGRAM PARAMETER
-9-14
NR. PARAMETER DESCRIPTION
» ALLOCATION OF HOTKEYS
085
TENSSW = Thread tension switch from A1 to A2 for this program. (By pres-
sing and holding the key you will switch to the 2
nd
tension as long
as you hold the key. You will go back to the 1
st
tension setting by
releasing the button) (also for two-needle machines B1and B2).
TENSTG = Thread tension switch from A1 to A2 for this program. (By pres-
sing the key you will switch to the 2 nd tension. By pressing it again
it will switch back to the 1 st tension setting. (also for two-needle
machines B1to B2).
NEEDLE = By pressing the key the machine will switch to the 2
nd
needle
position (needle up). By pressing it again it will switch back to
the 1
st
position (needle down).
TARGET = By pressing the key the machine will go to the target stitch positi-
on. Needle point just above the material.
(Target stitch position parameter 078 ).
SCENTER = For the machines with two-needles, this signal for seam middle
guide can be switched off.
TACKTYPE = With this function you can switch in the seam between stitch in
stitch and normal back tack.
POST BED = By pressing the key the post bed can be moved in or out.
PULLER = By pressing the key the puller wheel can be moved up or down.
086
Handwheel function (
1
) Same functions as parameter
085
, when the electronic handwheel is pushed
1
.
087 Knee switch function You have the same function as parameter 085 , when the knee switch is pushed.