Rev. 10/24/2019
TH-CART, MANUAL
Copyright 2019 Vestil Manufacturing Corp. Page 2 of 5
Signal Words:
This manual uses SIGNAL WORDS to direct the reader’s attention to important safety-related
messages. These messages describe uses of the product that could result in personal injury or property
damage. Each signal word corresponds to a specific hazard level. The following are definitions of signal
words that might appear in this manual
.
Identifies a hazardous situation which, if not avoided, WILL result in
DEATH or SERIOUS INJURY. Use of this signal word is limited to the most
extreme situations.
Identifies a hazardous situation which, if not avoided, COULD result in
DEATH or SERIOUS INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in
MINOR or MODERATE injury.
Identifies practices likely to result in product/property damage, such as operation
that might damage the product.
Hazards of Improper Use:
Vestil strives to identify all foreseeable hazards associated with the use of its products. However,
material handling is dangerous and no manual can address every conceivable risk. Ultimately, the most
effective way to prevent injury is to apply sound judgment whenever using this device.
Improper or careless use of this product could result in death or serious personal injuries.
•
Read and understand the entire manual before assembling, installing, using or servicing the
product.
•
Read the manual to refresh your understanding of proper use and maintenance procedures.
•
DO NOT attempt to resolve any problem(s) with the product unless you are both authorized to do so and
certain that it will be safe to use afterwards.
•
DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil.
Unauthorized modifications automatically void the Limited Warranty and might make the product unsafe to
use.
•
DO NOT exceed the maximum rated load (see Label 287 on product).
•
Inspect the product before each use.
A. DO NOT use this product if the inspection reveals structural damage. Examples of structural damage
include, but are not limited to, the following: 1) Cracked, broken or significantly deformed load-bearing
members; 2) cracked welds; 3) missing or deformed safety chain/strap; 3) corrosion, severe wear, or
other condition that affects the ability of the product to support weight or itself. Replace each part that
fails to pass an inspection, and DO NOT use the product until it is fully restored to normal condition.
B. DO NOT use the product if any unusual noise or movement is observed. If a malfunction occurs,
remove the unit from service and notify your supervisor & maintenance personnel about the issue.
•
DO NOT use this device UNLESS all product labels (see “Label Placement Diagram”) are readable and
undamaged.
Proper use, maintenance, and storage are essential for this product to function properly.
o
Always use this product in accordance with the instructions in this manual and consistent with any training
relevant to machines, devices, etc. used in conjunction with this product.
o
Keep the product clean & dry. Lubricate moving parts.
o
FOR HYDRAULIC UNITS: Do not use brake fluid or jack oils in the hydraulic system. If oil is needed, use
an anti-wear hydraulic oil with a viscosity grade of 150 SUS at 100°F, (ISO 32 cSt @ 40°C), or Dexron
transmission fluid.
o
Contact the manufacturer for SDS documentation