Vestil SPS-HD Series, Инструкция по эксплуатации, Страница: 4 / 6

Table of Contents Rev. 5/4/2020 SPS-HD MANUAL
Table of Contents Copyright 2017 Vestil Manufacturing Co. Page 4 of 6
ALWAYS lock both swiveling casters (under the bottom step) before climbing the steps. Lock each
caster by pressing down on the brake lever. The brake should press firmly against the surface of the
caster. The capacity of the step assembly is 350 pounds (159kg).
Improper use could result in serious personal injuries.
• Do not stand on the top shelf.
• The capacity (in pounds) per shelf is 500 lb. (227kg). Overall capacity of the cart is 1000 lb. (454.5kg).
• The capacity of the step assembly is 350 lb. (159kg).
• Each cart received label 446, which includes the capacity of the cart. See LABELING DIAGRAM on p. 4.
The capacity figure provided on label 446 indicates the net capacity of the cart, i.e. the weight of all
ancillary equipment (such as tools) added to the cart must be added to the weight of the load. The total
weight must be less than or equal to the rated capacity of the cart: Weight of load + weight of ancillary
equipment = (or less than) Capacity
INSPECTIONS & MAINTENANCE
Inspections and all necessary repairs should be performed by qualified persons. Compare the results of
each inspection to the RECORD OF SATISFACTORY CONDITION . Do not use the cart unless every part
is in satisfactory condition. If you have any questions about the condition of your cart, contact the
TECHNICAL SERVICE department. The phone number is provided on the cover page of this manual.
Never make temporary repairs of damaged or missing parts . Only use manufacturer-approved replacement
parts to restore the ladder to satisfactory condition.
At least once per month inspect the following:
1.) Frame and shelves – Look for damage and deformation, severe corrosion, etc. Check all welds
for cracks. Push the unloaded cart and listen for unusual noises and movement. Clean the
shelves and steps. Absorb water and other liquids.
2.) Step assembly – Confirm that the steps and springs operate normally. Both rubber feet should
firmly contact the ground and the steps should slide up-and-down easily when weight is applied
to them.
3.) Hardware – check all caster hardware/fasteners and spring pins. Tighten all loose fasteners.
4.) Labels – confirm that each label is in place and in good condition (see “Labeling Diagram”
below).
LABELING DIAGRAM
Each unit should be labeled as shown in the diagram. Label content and location are subject to change
so your product might not be labeled exactly as shown. Compare the diagram below to your RECORD OF
SATISFACTORY CONDITION . If there are any differences between actual labeling and this diagram,
contact TECHNICAL SERVICE . Replace all labels that are damaged, missing, or not easily readable (e.g.
faded). To order replacement labels or to inquire whether your unit is properly labeled, contact the technical
service and parts department online at http://www.vestilmfg.com/parts_info.htm or by calling (260) 665-
7586 and asking for the Parts Department.
A:
Label 446 (applied to front edge of top step)
A
B
B:
Label 608 (applied to front edge of top step)