Vestil SHEET-R-57, Инструкция по эксплуатации

Страница: 4 / 5

Table of Contents Rev. 6/12/2020 SHEET-R-57 MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Corp. Page 4 of 5
INSPECTIONS AND MAINTENANCE
When conducting the following inspections, compare your observations to the RECORD (p. 3) to
determine if a component is in satisfactory condition. Do not use the product unless every component
is in satisfactory condition. Cosmetic changes, like damaged paint/powder coat do not constitute
changes from satisfactory condition. However, touchup paint should be applied to all affected areas as
soon as damage occurs. Contact TECHNICAL SERVICE (contact information appears on the cover
page) to order replacement parts.
At least once per month perform the following inspections.
1. Check the surfaces of the rack for dirt or other matter. Clean the surfaces.
2. Examine all hardware/fasteners. Replace damaged hardware (e.g. worn, corroded, bent). NOTE:
Lock nuts must be replaced if they are disconnected/removed.
3. Examine posts and cross bars for wear, breaks, corrosion/rusting, damage, and metal fatigue. Pay
particular attention to the tops of the upright arms and all pin holes.
4. Check all labeling. Replace labels that are damaged or not easily readable. Refer to LABELING
DIAGRAM
below. Every label must be easily readable from a reasonable, safe distance from the
rack.
5. Examine the whole structure for severe rusting/metal erosion, rot, thinned regions. If rusting is
purely superficial, remove the rust/corrosion with a steel bristle brush or steel wool. Clean the
affected area and apply touchup paint. If rusting, rot, or thinning might have weakened the material,
tag the rack “Out of service” and contact TECHNICAL SERVICE for advice.
LABELING DIAGRAM
The unit should be labeled as shown in the diagram. However, label content and locations are
subject to change so your product might not be labeled exactly as shown. Replace all labels that are
damaged, missing, or not easily readable (e.g. faded). To order replacement labels, contact the
technical service and parts department online at http://www.vestilmfg.com/parts_info.htm . Alternatively,
you may request replacement parts and/or service by calling (260) 665-7586 and asking the operator to
connect you to the Parts Department.
B: Label 204
A: Label 1120
A
B