Vestil POW-CAR-AR5, Инструкция по эксплуатации

Страница: 8 / 13

Table of Contents Rev. 3/4/2019 POW-CAR-AR5 MANUAL
Table of Contents Copyright 2019 Vestil Manufacturing Corp. Page 8 of 13
Installation and Assembly:
The turntable must be securely anchored to the floor before being put into service. Five (5) access
ramps are provided with the unit that require no assembly and simply drop into place.
1. Move the machine to the installation site. Install the machine only on an even, level surface.
2. Fasten the machine to the floor with anchor bolts. There are 2 anchoring tabs located close to the power unit.
Each of the tabs has a hole for an anchor bolt. Your building engineer should evaluate the installation site and
select
3
/
8
in. anchor bolts of a length appropriate for the location. Install the anchor bolts.
3. Shim and grout under the frame as necessary to level the turntable.
4. Install the ramps. The inner edge of each ramp is formed/bent to be vertical when it is installed. There are 3
slots in the formed edge of each ramp. Install the sections by sliding the slots over the welded mounting studs
attached to the edges of the turntable. The diagram (above) indicates where each ramp connects to the
turntable.
5. Plug the power unit into an AC power source that
matches the voltage of your motor.
6. Test the powered functions:
a. Turntable rotation: press the foot pedal to
initiate rotation. The turntable will rotate as
long as the pedal is pressed.
b. Delta speed controller: refer to the Delta
operation manual. The dial in the lower left
corner of the display panel controls turntable
rotation speed. Turn the dial clockwise to
increase speed and counterclockwise to
reduce speed.
After installing the turntable, increase rotation speed to maximum. The number displayed on the
screen of the control is the approximate number of revolutions per minute. Make note of the maximum
rotation speed (rpm) in your Record of Normal Condition . Reset the speed to minimum when you are
finished.
Ramps
A: Part no. 20-514-138; Quantity = 1
B: Part no. 20-514-137; Quantity = 1
C: Part no. 20-514-136; Quantity = 3
A
B
C
C
C
Anchor tab
Welded mounting stud
Slot in formed edge
Foot
pedal
(inside
yellow
guard)
Power cord
Motor
speed
controller