Rev.
5/19/2015
PEL-88-A-SWA,
MANUAL.doc
Copyright 2015 Vestil Manufacturing Co.
Page 8 of 11
Loading Stretch Wrap:
The stretch wrap holder is easily disassembled and reassembled to facilitate rapid loading of new rolls and removal of
empty rolls. To assemble the stretch wrap holder, follow steps 1-5 below. The holder will accommodate rolls of
wrapping material up to 20in. long. [NOTE: Numbers in parentheses () in steps 1-5 below correspond to item
numbers.]
Stretch wrap holder assembly
3
5
1
4
1
Item
no.
Part no.
Description
Quantity
1 20-014-006
Wrap
retainer
2
2 33426
3
/
4
” – 10ga. machinery bushing
5
3 20-538-001
Carriage
weldment
1
4 20-538-003
Threaded
spindle
1
5 20-145-008
Spindle
handle
1
Item no. 2
not shown
Step 1: Slide 3 machinery
bushings (2) onto the shaft
of the spindle (4).
Step 2: Install a wrap retainer (1). The
bushings installed in step 1 will fit inside
a cavity in the underside of the retainer.
Machinery
bushing
Retainer
Step 3: Install a roll of stretch wrap;
then install the other retainer.
Step 4: Insert the threaded end of the
spindle through the hole in the end of
the carriage arm; then slide 2 more
machine bushings onto the spindle.
Step 4: Wind the spindle
handle onto the end of the
spindle and tighten it against
the bushings.
Roll of
stretch
wrap
Wrap
retainer
Machinery
bushings
Spindle
handle
Carriage
arm
NOTE: The tightness of
the handle connection
determines the degree to
which the wrap stretches.
The tighter the
connection the more the
wrap will stretch.
Operation:
This product is not self-propelled. To move the unit, lower the carriage; then push it carefully to the work location.
Vertical travel of the carriage is controlled electronically via the touchpad (see item no. 12 on p. 4). Use the
RAISE and LOWER buttons to adjust the vertical position of the carriage as the application requires.
The travel speed of the carriage is adjustable. Press the FASTER button to increase travel speed, or press the
SLOWER button to decrease speed. The SPEED gauge between the buttons indicates the current speed setting.
To wrap an object, attach the free end of the wrap to it. Push the wrapping machine around the object to
dispense wrap. When the wrapping process is finished, cut the wrap (for example with a utility knife). Lower the
carriage and move the unit to its storage location. Apply the caster brakes (see FIG.
Store the wrapping machine in a dry, indoor location to protect the electronic components.
