Vestil MEZZ-200-DW, Руководство пользователя

Страница: 2 / 10

Table of Contents Rev. 9/28/2020 MEZZ-KD MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Co. Page 2 of 10
SIGNAL WORDS
This manual uses SIGNAL WORDS to draw attention to uses of the product that could result in
personal injuries, as well as the probable seriousness of those injuries. Other signal words call attention to uses
likely to cause property damage. Signal words used in this manual appear below along with the definition of
each word.
Identifies a hazardous situation which, if not avoided, WILL result in DEATH or
SERIOUS INJURY. Use of this signal word is limited to the most extreme situations.
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or
SERIOUS INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in MINOR or
MODERATE injury.
Identifies practices likely to result in product/property damage, such as operation that might
damage the product.
SAFETY INSTRUCTIONS
Vestil strives to identify all foreseeable hazards associated with the use of its products. However,
material handling is dangerous and no manual can address every conceivable risk. The most effective
way to prevent injury is to apply sound judgment whenever using this device.
If this product is assembled, installed, and/or used improperly or carelessly, serious
personal injuries or death could occur.
•
Read and understand the entire manual before assembling, installing, using or servicing this gate
system. Keep a copy of this manual in an accessible location known to all persons who use the gate
system. Additional copies of this instruction manual may be downloaded from
https://www.vestil.com/page-manuals.php .
•
Keep the bottom gate down at all times except when placing or removing materials inside the gate.
•
DO NOT modify the product in any way without first obtaining written approval from Vestil. Unapproved
modifications automatically void the LIMITED WARRANTY (p. 10) and might make the product unsafe to
use.
•
Inspect the product as described in the INSPECTING AND MAINTAINING THE SYSTEM section on p.
9. DO NOT use this product if the gate system is damaged. Examples of damage include, but are not
limited to, the following: 1) Cracked, broken or significantly deformed frame members; 2) cracked welds;
3) damaged lumber; and 4) corrosion, severe wear, or other condition that interferes with normal
operating condition. Replace every part that is not in satisfactory condition . DO NOT use the product until
it is fully restored to satisfactory condition. If the gate cannot be restored to satisfactory condition,
permanently remove it from service.
•
DO NOT use this device UNLESS all labels are readable and undamaged. See LABELING DIAGRAM
on p. 9.
Proper maintenance is essential for this product to remain in normal condition for as long
as possible.
o
Keep the product clean & dry.
o
Periodically lubricate pivot points.
o
Routinely check the soundness of the entire structure. All frame members should be rigid and straight.
Fasteners should be securely connected and undamaged.