6/10/2021
LM-HP MANUAL
Vestil Manufacturing
Page
5
of
6
(A)
Inspect the following before each use and AT LEAST once per month:
i.
Hook spring latch: Confirm original condition and proper operation of the spring latch.
ii.
Hook, swivel, & shackle: Check each component for significant wear, looseness,
distortion & damage.
iii.
Hook plate: Look for damage like significant wear, deformation, cracking, thinning, etc.
iv.
Safety strap: Closely examine the strap and the strap hook. Check the strap for thinned,
frayed, torn, or severely worn areas. Examine the strap hook for bends, cracks, and
elongation.
v.
Labels/tags: Frequently examine the tag. Confirm that each label is present, in good
condition, and easily readable. See
(B)
Load test:
At least once per year, use the LM-HP to lift a full capacity load. Observe the unit from a
safe distance. Monitor the hook, shackle, and swivel (-S models). Hold the load for ~1 minute;
then lower it and disconnect it from the hook. After the load is removed, closely inspect all
parts and surfaces of the entire LM-HP for fatigue, cracks, or deformations. If any such
damage is observed, permanently remove the unit from service.
Maintenance
Proper maintenance and storage are essential for this product to function properly.
(A) Clean the unit before inspecting it.
(B) Perform all necessary adjustments, replacements and/or repairs. ONLY install replacement
parts supplied, or approved, by the manufacturer.
LABELING DIAGRAM
Label content and location are subject to change so your product might not be labeled exactly
as shown. Compare the diagram below to your
RECORD OF SATUSFACTORY CONDITION
. If
differences between actual labeling and this diagram exist, contact
TECHNICAL SERVICE
. Replace
all labels that are damaged, missing, or not easily readable (e.g. faded). To order replacement
labels, or to inquire whether your unit is properly labeled, contact the technical service and parts
http://www.vestilmfg.com/parts_info.htm
or by calling (260) 665-7586 and
asking for the Parts Department.
Tag 1054: Obverse side
- Product specifications
[Tag attaches to handle of unit via zip-tie]
Tag 1054: Reverse side
– Safety messages
Attach tag to
