Vestil LAD-10-14-G-EZ, Инструкция по эксплуатации

Страница: 15 / 20

Table of Contents Rev. 11/18/2019 LAD-EZ (6-12 STEPS), MANUAL
Table of Contents Copyright 2019 Vestil Manufacturing Co. Page 15 of 20
Step 5: Install the outriggers as diagrammed (11 and
12 step models only).
Step 4: Install the plugs, caps, axle and wheels.
a) Install the plastic plugs and square caps in the front legs. First, press the 1in. plastic plugs into the front legs.
Then, press the square caps over the plugs and onto the ends of the legs. If necessary, use a rubber mallet to
gently tap the plugs and caps into place.
b) Insert the axle through the axle receiver of the back leg weldment.
c) Then, slide the wheels onto the ends of the axle. Secure the wheels to the axle by inserting a cotter pin through
the pinhole in each end of the axle. Periodically lubricate the axle to allow the wheels to rotate freely.
1in. black
plastic plug
1in. x 1in.
square cap
5
/
16
in.
lock nut
Left side
outrigger
Outriggers
installed
Ladder
assembly
Axle
Wheel
Cotter pin
Axle
receiver
Cotter pin
Axle
Cotter pin
Axle
Wheel
Outrigger (right)
5
/
16
” – 18 x
1” bolt
AND
5
/
16
in. flat
washer
Right side
outrigger