Table of Contents
Rev. 2/27/2020 HDOF, HDOS, FDOL, HDOSC, HDOR, HDOC, MANUAL
Table of Contents
Copyright 2020 Vestil Manufacturing Corp. Page 3 of 4
INSPECTIONS AND MAINTENANCE
Written record — Before using the product for the first time, make a written record of its
appearance. Describe the condition of the frame, hardware, and mechanisms. Take photographs of
each feature and add them to the record. Take photographs of all labels applied to the product.
Describe where each label is located. Collate all writings and photos into a single file. This file is a
record of the dolly in satisfactory condition.
When conducting the following inspections, compare your observations to the record to determine if
a component is in satisfactory condition. Do not use the product unless every component is in
satisfactory condition. Cosmetic changes, like damaged paint/powder coat do not constitute changes
from satisfactory condition. However, touchup paint should be applied to all affected areas as soon as
damage occurs. Contact Technical Service (contact information appears on the cover page) to order
replacement parts.
Before each use — perform the following inspections.
1. Check the surface of the product for dirt or other matter. Clean the surfaces.
2. Examine hardware & fasteners, including but not limited to bolts, nuts, and pins. Replace damaged,
worn, or corroded hardware.
3. Examine frame elements and casters for excessive wear, rot, breaks, corrosion/rusting, damage,
and metal fatigue.
4. Check all labels. Replace labels that are damaged, missing, or not easily readable.
5. Examine the whole structure for severe rusting/metal erosion, rot, thinned regions. If rusting is
purely superficial, remove the rust/corrosion with a steel bristle brush or steel wool. Clean the
affected area and apply touchup paint. If rusting, rot, or thinning has weakened the material, contact
technical service for advice.
LABELING DIAGRAM
The unit should be labeled as shown in the diagram. However, label content and locations are
subject to change so your product might not be labeled exactly as shown. Replace all labels that are
damaged, missing, or not easily readable (e.g. faded). To order replacement labels, contact the
technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm
. Alternatively,
you may request replacement parts and/or service by calling (260) 665-7586 and asking the operator to
connect you to the Parts Department.
658
287
LABELS CAN ALSO BE APPLIED TO THE
UNDERSIDE OF THE DOLLY, IF NEEDED.
