Vestil FHSN Series, Инструкция по эксплуатации

Страница: 10 / 17

Table of Contents Rev. 7/9/2020 FHSN MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Corp. Page 10 of 17
Step 2:
Fasten the upright weldments
(“
uprights”) to the yokes. Then fasten two beam clamps to the beam
bracket of each upright. NOTE: Models FHSN-6-20 and FHSN-8-20 require shim (28-113-022).
Lay the leg assemblies flat on the ground. Slide the uprights into the corresponding receivers of the yokes.
Align the pinhole in each upright with the pinhole in a yoke receiver as shown in Fig. 2A below. Use an adjustment
pin to attach each upright to a leg receiver. Remove the hitch clip from the end of the pin. Insert the pin through
the pin holes and reinstall the hitch clip.
Fig. 2Bi : Beam Clamp-to-Bracket Connection
½ in. -13 x 2in.
A325 structural
bolt (
19211-B)
Welded beam clamp
½ in. -13 A325
structural nut
19211-A
½ in. zinc-plated lock
washer (33626)
Fig. 2A : Upright-to-Leg Assembly
Connections
Pin upright to
yoke
Adjustment pin
Adjustment pin
Hitch pin
Beam clamp
Hitch clip
Welded beam clamp
Round
shim
Step 3: Couple the I-beam to the uprights.
Insert the flange of the I-beam into the gap between the beam clamp and the top of each upright (beam bracket);
then secure the flange on the opposite side by installing the remaining beam clamp as shown in the diagrams
below.
Fig. 3A: I-beam Connection to Beam Bracket of Upright
FIG. 3Bi: Exploded view of beam
connection
Beam bracket
Upright
Beam flange
Leg
receiver
FIG. 3Bii: Exploded view of beam
connection (FHSN-6-20 & FHSN-8-20)
Beam flange
Fig. 2Bii : Beam Clamp-to-Bracket Connection
FHSN-6-20 & FHSN-8-20
½ in. zinc-plated lock
washer (33626)
½ in. -13 A325
structural nut
19211-A
½ in. -13 x 2in.
A325 structural
bolt ( 19211-B)
Beam clamp
Shim (28-113-022))
Beam clamp