2
Mechanical Operation • Series FM
1.)
Remove the lever from right side of bumper box and
insert it into the socket of the back plate (the socket is
on right hand side).
2.)
Pull the handle back until the leveler plate is fully
extended and leaning back towards the ramp.
3.)
Push the handle forward to allow the lip
plate to extend and fall on the bed of the trailer.
Do not operate without a truck in place as the operator
may lose balance.
4.)
Remove the lever and place it in the bumper box.
5.)
When loading and unloading is complete, remove
chocks and allow trailer to pull away. The Edge-O-
Dock will return to its original position.
Hand Pump Operation • Series PP
1.)
Rotate the valve on the pump clockwise to close the
fluid return valve. Raise the dockleveler with the hand
pump. When the dockleveler clears the trailer bed and
fully extends, open the return valve to allow the lip
to settle on the trailer bed.
Be sure to leave the
fluid return valve open to allow the dockleveler to
float with the trailer.
2.)
When loading/unloading is complete, remove the
chocks and allow the trailer to pull away. The
Edge-O-Dock will return to its original position.
Electric Operation • Series PE
1.)
Push
"RAISE"
button on control box. The dockleveler
will begin to rise. When the dockleveler lip reaches
full extension, release the button. It will lower and
settle on the trailer bed.
2.)
When loading/unloading is complete, remove the
chocks and allow the trailer to pull away. The
Edge-O-Dock will return to its original position.
Ordering Replacement or Extra Parts
Our company takes pride in using the finest available
parts for our equipment. We are not responsible for equipment
failure resulting from the use of unapproved replacement parts.
To order replacement or extra parts for your equipment contact
Customer Service at the factory. In any correspondence with
the factory please include the Serial Number which is inscribed
on the nameplate of the piece of equipment. Use only the part
numbers provided in this Owner's Manual. Please indicate the
motor phase and voltage that the equipment is operating on.
Fork Truck
Boom
Chain
Self-locking
Clamp
WARNING:
KEEP HANDS AND
FINGERS OUT OF
HINGE AREA!
LOADING INSTRUCTIONS
The load capacity rating as inscribed on the
nameplate of your unit designates its net capacity. This
capacity must never be exceeded, as permanent damage or
personel injury may result.
UNPACKING AND HANDLING INSTRUCTIONS
CAUTION
Read instructions completely before adjusting.
Follow instructions carefully.
Use end wrench, not crescent wrench, as crescent
may slip.
Recommended unpacking and handling is shown
below.
Recommended dock height is 50".
Service range is +5" to -5".
OPERATING INSTRUCTIONS
I.)
Back trailer slowly against Edge-O-Dock bumpers.
Turn off the engine and set the emergency brake on
truck. Position wheel chocks (by others) per OSHA
requirements to prevent trailer movement.
II.)
Follow the instructions below according to the model
of Edge-O-Dock you have.
