6
5. OPERATION
(video clip of the operation for steel drums is available upon request)
The following outlines the general operation of Drum Grabs. Differences
for specific models follow this section.
1. Place unit on floor or flat surface easily accessible to fork truck. Be
sure that “T” bolts are sufficiently unthreaded to allow forks to enter
pockets.
2. Adjust the hoop according to the drum diameter
3. Carefully slide forks (do not use fork extensions) into drum grab’s fork
pockets. Be sure forks are in pockets as far as possible.
4. Hand tighten “T” bolts to secure unit to forks (hand tool may be used
but is not necessary). Recheck bolts periodically during use for
tightness.
5. If not already done, unfold grab jaws.
6. Raise unit and approach drum so that the jaws come in contact with
the drum just below the upper rolling rib of the drum. (Fig 1)
7. Move unit forward onto drum, lowering jaws slowly as you move. Jaws
will open and close around drum. (Fig 2)
Figure 1
Figure 2
