Vestil DCBB Series, Быстрый старт

Страница: 5 / 6

TABLE OF CONTENTS 7/23/2021 DCBB, MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Co. Page 5 of 6
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
After installing the bollard system and before putting it into service, make a record of its
condition. Record the condition and appearance of both of the bollards, the chains, gate
chain bar and the gate pins, all 4 mounting brackets, and all fasteners (anchor bolts, anchors,
nuts, screws, etc.). Thoroughly photograph the system from multiple angles. Include close
range photographs of the bases of the bollards to show all anchoring hardware, mounting
brackets and fasteners, quick links, gate pins, and labeling. Collect all photographs and
writings in a single file. This file is a record of the system in satisfactory condition. Compare the
results of all inspections to this RECORD to determine whether the system is in satisfactory
condition. Do not use the system unless all components in satisfactory condition. Purely
cosmetic changes, like damaged paint or powdercoat, are not changes from satisfactory
condition. However, touchup paint should be applied as soon as damage occurs.
INSPECTIONS & MAINTENANCE
NOTICE
Inspections and all necessary repairs should be performed by qualified persons.
Compare the results of each inspection to the RECORD OF SATISFACTORY CONDITION . Do
not continue to use the visual barrier system unless every part is in satisfactory condition. If you
have any questions about the condition of your DCBB, contact the TECHNICAL SERVICE
department. The phone number is provided on the cover page of this manual. Never make
temporary repairs of damaged or missing parts . Only use manufacturer-approved
replacement parts to restore the unit to satisfactory condition.
I nspect the following at least once per month. Maintain the system by replacing all items
that are not in satisfactory condition.

Bollards: Try to wiggle the bollards. to determine the soundness of the connections between
the anchor bolts and the surface. If the bollard can wobble, determine if any of the bolts are
loose and tighten them. If the concrete around the anchors is damaged and the anchor is
loose, the bollard will have to be installed in another location. Clean dirt and grime from the
surface of the bollard.

Mounting brackets: Make sure that all 4 brackets are solidly fastened to the bollards. Look for
cracks and significant rusting/corrosion.

Gate assembly (chains, quick links, gate chain bar): Check all quick links and the links of
both chains for cracks, breaks, twists, and other damage. Examine the gate chain bar for
damage. Pay particular attention to the gate pins.
LABELING DIAGRAM
Label content and location are subject to
change so your product might not be labeled
exactly as shown. Compare the diagram below
to your RECORD OF SATISFACTORY CONDITION . If
there are any differences between actual
labeling and this diagram, contact TECHNICAL
SERVICE . Replace all labels that are damaged,
missing, or not easily readable (e.g. faded). To
order replacement labels or to inquire whether
your unit is properly labeled, contact the
technical service and parts department online
at http://www.vestilmfg.com/parts_info.htm or
by calling (260) 665-7586 and asking for the Parts
Department.
Label 821
Label 204
821
204
204