Rev. 1/31/2020
CYL-P-X MANUAL
Copyright 2020 Vestil Manufacturing Corp. Page 5 of 6
INSPECTIONS AND MAINTENANCE
Regular inspections and maintenance are essential. Always inspect and maintain this
product in accordance with the instructions in this manual.
Inspections and repairs should be performed by qualified persons. Compare the results of each
inspection to the
. Do not use the caddy unless all parts
are in satisfactory condition. Replace all parts that are not in satisfactory condition before using the
caddy again. Only use manufacturer-approved replacement parts to restore the caddy to satisfactory
condition.
DON’T GUESS!
If you have any questions about the condition of your caddy, contact
the
TECHNICAL SERVICE
department.
The phone number is provided on the cover page of this
manual.
Never make temporary repairs of damaged or missing parts
.
Every lift
The operator of the caddy must inspect the caddy and cylinder surfaces before every lift. Check the
caddy and all cylinders for dirt or other surface debris. Clean the surfaces.
Monthly Inspections
– At least once per month a qualified person must perform the following
inspections. Written reports should be prepared for every monthly inspection including inspections
1.
Frame elements:
Examine all frame elements for deformation, cracks, excessive wear,
corrosion/rusting, and metal fatigue. Pay particular attention to the base plate. Examine the whole
structure for severe rusting/metal erosion, rot, thinned regions. If rusting is purely superficial, remove
it with a steel bristle brush or steel wool. Clean the affected area and apply touchup paint. If rusting,
rot, or thinning has weakened the material, contact
2.
Snap hooks and chains:
Examine the chains and snap hooks. Hooks should not be bent, cracked,
twisted, or otherwise deformed. Latches should automatically close. Chain links should not be
damaged, e.g. bent, cracked, or stretched.
3.
Labels:
Check all labels. Labels are shown in the
(below). Replace labels
that are missing, damaged, or not easily readable.
LABELING DIAGRAM
The unit should be labeled as shown in the diagram. However, label content and location are
subject to change so your product might not be labeled exactly as shown. Replace all labels that are
damaged, missing, or not easily readable (e.g. faded). To order replacement labels, contact the
technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm
. Alternatively,
request replacement parts and/or service by calling (260) 665-7586 and asking the operator to connect
you to the Parts Department.
A: Label 287
B: Label 821
A
B
