3/11/2020
CYL-LT-1MANUAL
Copyright 2020 Vestil Manufacturing Corp. 6 of 7
RECORD OF SATISFACTORY CONDITION
Record the condition of the lifter before putting it into service. Thoroughly photograph the unit from
multiple angles. Include close range photos of all labeling, the cylinder receiver, the cable eyelet that
attaches the cable to the top of the receiver, fasteners (bolts, nuts), winch, platform, wheels, and welds.
Collate all photographs and writings into a single file. Mark the file appropriately to identify it. This file is
a record of the lifter in satisfactory condition. Compare the results of all inspections to this record to
determine whether the unit is in satisfactory condition. If the lifter is not in satisfactory condition, repair it
before returning it to service. Purely cosmetic changes, like damaged paint/powdercoat, do not
constitute changes from satisfactory condition. However, touchup paint should be applied to all affected
areas as soon as cosmetic damage occurs to prevent rusting and corrosion. If left unaddressed,
rusting/corrosion will alter the lifter from satisfactory condition and could make it unsafe to use.
INSPECTIONS AND MAINTENANCE
Inspections and repairs should only be performed by qualified persons. Compare the results of each
inspection to the
. Do not use the lifter unless all parts are
in satisfactory condition. Replace parts that are not in satisfactory condition before using the lifter
again.
DON’T GUESS!
If you have any questions about the condition of your lifter, contact the
department.
The phone number is provided on the cover page of this manual.
Never make temporary repairs of damaged or missing parts
. Only use manufacturer-approved
replacement parts.
At least once per month:
•
Examine the frame elements (mast, platform, handle, cylinder receiver) for cracked welds, metal
fatigue, rust, and corrosion that affect the structural integrity of the lifter. The structure should be clean,
square and rigid, and free of rust and corrosion. Remove dirt and debris.
•
Inspect the winch and cable. Pulleys should roll smoothly as cable passes over them. The cable
should be free of elongations, bird-caging, thinned regions, and broken strands. The winch should turn
smoothly in both directions and ratchet normally. A brake should automatically apply whenever the
winch handle is stationary, i.e. the cylinder receiver should maintain position. The winch should be
solidly fastened to the frame of the lifter.
•
Check the ratchet and ratchet strap. Confirm normal operation and condition. If either the strap or the
ratchet is damaged, tag the unit out of service and install manufacturer-approved replacement parts.
•
Wheels. Confirm that each wheel rotates smoothly and is securely fastened to the lifter. The wheel
material should not be cracked, warped, dry rotted, etc.
•
Labels: Confirm that every label shown in the
easily readable from a reasonable distance.
B (Label 287)
A: Label 728
LABELING DIAGRAM
The unit should be labeled as shown
in the diagram. However, label content
and location are subject to change so
your product might not be labeled
exactly as shown. Replace all labels that
are damaged, missing, or not easily
readable (e.g. faded). To order
replacement labels, contact the technical
service and parts department online at
http://www.vestilmfg.com/parts_info.htm
Alternatively, you may request
replacement parts and/or service by
calling (260) 665-7586 and asking the
operator to connect you to the Parts
Department.
A
B